Drill a 1” hole centered on your desired location

Assemble your GeeFix wall anchor system as shown above by threading the supplied blue pullcord through the round wall plug, the curved back plate, and back through the wall plug.

While holding onto the pullcord, feed the curved back plate into the hole and center on the 1″ hole

While keeping light tension on the pullcord slide the wall plug into the 1″ hole to align with the holes on the back plate

While keeping firm tension on the pullcord, screw the large screw into the center hole until the GeeFix becomes firm, but do not overtighten. Keeping tension on the pullcord will keep the back plate in place during installation.

Pull out the pullcord but do not discard. You can use the same pullcord on additional GeeFix installations.

Insert the 2 smaller screws on either side of the large screw and tighten until the GeeFix is firmly secured but do not overtighten.

Remove the center screw

Now that your GeeFix system is installed, you can either use the center screw to fix your item, or use your own mounting hardware in its place.